6.10 Adjustment of the Paper Feeding System
Adjust the laser writing start position in the primary scanning direction with the lower drawer. (05-4005,
05-4006)
If deviation still occurs, perform the following:
6.10.1
Sheet sideways deviation caused by paper feeding
<Procedure>
The center of the printed image shifts to the front
side. Move the guide to the front side (Arrow
(A) direction in the lower figure).
Feeding direction
Fig.6-47
Bypass feeding
(1)
Loosen the screw.
(2)
Move the entire guide to the front or rear
side.
(3)
Tighten the screw.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
[Rear]
Center
[Front]
6 - 62
The center of the printed image shifts to the rear
side. Move the guide to the rear side (Arrow
(B) direction in the lower figure).
Feeding direction
Fig.6-48
(A)
Fig.6-49
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[Rear]
Center
[Front]
(B)