Notes:
•
"-" means "Not acceptable".
•
The bridge unit (KN-2520N) is necessary for installation of the finisher (MJ-1033, MJ-1107,
MJ-1108).
•
The finisher (MJ-1107/1108) is necessary for installation of the hole punch unit (MJ-6103N/E/
F/S).
•
The finisher (MJ-1032N) is necessary for installation of the hole punch unit (MJ-6007N/E/F/
S).
•
The finisher (MJ-1033) is necessary for installation of the hole punch unit (MJ-6008N/E/F/S).
•
The antenna (GN-3010) is necessary to enable the wireless LAN Module (GN-1060).
Two Antenna (GN-3010) can be installed in the Wireless LAN Module (GN-1060).
•
•
The Work Table (KK-4550) and the e-BRIDGE ID Gate (KP-2004/2005) cannot be installed
together.
•
If MJ-1032N is installed in the 50-cpm model, the performance speed other than that or the
non-sort mode will be equivalent to the one when installed in the 45-cpm model.
•
If MJ-1033 is installed in the 50-cpm model, the performance speed will be equivalent to the
one when it is installed in the 45-cpm model.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
2 - 22