Toshiba e-STUDIO206L Service Manual page 241

4.12.3 Removing developer material
(1) Take out the developer unit
( P. 4-100 "4.12.2 Developer unit").
(2) Remove 2 screws and slide the developer
unit upper cover to the direction of the arrow
and take it off.
Notes:
When installing the developer unit upper
cover, make sure that the side seal comes
between the developer unit upper cover and
rubber seal on the cover.
(3) Remove the developer material from rear
side.
Notes:
1. When removing the developer material,
be careful not to drop the developer
material on the gears of the developer
unit.
2. When cleaning the developer unit, never
attempt to use solvent.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Developer unit upper cover
Fig. 4-286
Rubber seal
Developer unit
upper cover
Fig. 4-287
Fig. 4-288
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 101
Side seal
DISASSEMBLY AND REPLACEMENT
4