Adjustment Of Hole Punch Unit (Mj-6008) - Toshiba e-STUDIO206L Service Manual

6.19 Adjustment of Hole punch unit (MJ-6008)

6.19.1 Sensor output adjustment
Perform this adjustment after replacing any of the hole punch control PC board (HP), horizontal
registration detection sensors (S39-1 and S39-2, light-emitting PC board and light-receiving PC board)
and punch waste full sensors (S40-1 and S40-2, light-emitting PC board and light-receiving PC board).
This adjustment is performed with a DIP switch [2] and a push button switch [3] on the hole punch
control PC board (HP) [1].
[1]
6
CPU
LED
[2]
[3]
ON
2 3 4
1
Fig.6-141
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
6 - 121