Registration Of The Number Of Punch Holes - Toshiba e-STUDIO206L Service Manual

6.19.2

Registration of the number of punch holes

This registration is to have the Finisher identify which type (number of punch holes) of the Hole Punch
Unit is installed, by storing them in the IC on the hole punch control PC board (HP). Therefore this
registration is required whenever you have replaced the hole punch control PC board (HP).
This registration is performed with a DIP switch [2] and a push button switch [3] on the hole punch
control PC board (HP) [1].
[1]
CPU
LED
[2]
[3]
ON
1 2 3 4
Fig.6-144
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507 © 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 124