State Transition Diagram Of Self-Diagnosis Modes - Toshiba e-STUDIO206L Service Manual

Mode For start
Password [4] + [8] + [9]
reset mode + [POWER]
Notes:
1. When the optional FAX unit is installed, Faxes received automatically during the self-
diagnosis mode may not be printed out. Be sure to disconnect the modular code from the line
connectors (LINE1, LINE2) of the equipment before starting the self-diagnosis mode. Also, be
sure to finish the self-diagnosis mode by turning the power OFF and back ON before
connecting the modular code.
2. Do not enter any of the modes shown below since they are provided only for production. If
you do so, the equipment may not be restarted.
[2]+[CLEAR]+[POWER]
[7]+[CLEAR]+[POWER]
[8]+[CLEAR]+[POWER]
[9]+[CLEAR]+[POWER]
[D] State transition diagram of self-diagnosis modes
*1. Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
*2. Mode shown in the table "[C] List of modes"
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SELF-DIAGNOSIS MODES
Contents
Resets the administrator password and
service password.
[POWER]
Normal
ON
Authentication
Warming up
Ready Each mode
[POWER]
OFF
*1
To user
Fig.5-1
5 - 2
For exit
[POWER]
OFF/ON
Self-diagnosis
mode
screen
*2
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Display
-