[E440] Feed cover opened during printing
Classification
Cover open jam
Proce
Check item
dure
1
Is the feed cover open?
Is the feed cover opening/
2
closing detection sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[9]/[E])
3
Replacing board
Parts to be replaced
Feed cover opening/closing
detection sensor
LGC board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Feed cover open jam
Result
Yes
Remove the paper if there is any, then close
the cover.
No
Yes
No
•
Check if the connector of the feed cover
opening/closing detection sensor is
disconnected.
•
Check if the connector CN311 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the LGC
board is short circuited or open circuited.
•
Replace the feed cover opening/closing
detection sensor.
•
Replace the LGC board.
•
Replace the LGC board.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 70
Error content
Measure
Remark
Next
Step
2
3