(29) Run the harness through the clamp. Then
run it through the hole in the equipment and
wire it to the front side as shown in the right-
hand figure.
(30) Connect 1 connector and install 3 clamps.
(31) Connect 1 connector.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 188
Fig. 4-537
Fig. 4-538
Fig. 4-539