Adjustment Of The Finisher (Mj-1032); Alignment Position Adjustment (Front); Alignment Position Adjustment (Rear); Stapling Position Adjustment - Toshiba e-STUDIO206L Service Manual

6.14 Adjustment of the Finisher (MJ-1032)

Notes:
Before performing each adjustment, make sure that all covers (incl. those of the finisher and
equipment) are closed. Otherwise, no power is supplied to the Finisher and the adjustment may
not be performed properly.
6.14.1 Alignment position adjustment
[A] Alignment position adjustment (front)
This adjustment is performed in the Adjustment Mode (05-4822-0) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
[B] Alignment position adjustment (rear)
This adjustment is performed in the Adjustment Mode (05-4822-1) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.14.2

Stapling position adjustment

[A] Stapling position adjustment (rear 1-point)
This adjustment is performed in the Adjustment Mode (05-4823-0) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
[B] Stapling position adjustment (rear 1-point / "R" series size)
This adjustment is performed in the Adjustment Mode (05-4823-1) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
0.2mm
-3.0 mm to 3.0 mm
Increasing the value The alignment plate moves to the center.
Decreasing the value The alignment plate moves to the edge of paper.
0.2mm
-3.0 mm to 3.0 mm
Increasing the value The alignment plate moves to the center.
Decreasing the value The alignment plate moves to the edge of paper.
0.2mm
-5.0 mm to 5.0 mm
Increasing the value The distance between the stapling position and the
edge of the paper becomes longer
Decreasing the value The distance between the stapling position and the
edge of the paper becomes shorter.
0.2mm
-1.0 mm to 5.0 mm
Increasing the value The distance between the stapling position and the
edge of the paper becomes longer
Decreasing the value The distance between the stapling position and the
edge of the paper becomes shorter.
6 - 86
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved