Toshiba e-STUDIO206L Service Manual page 27

Toner supply ............................ Automatic toner density detection/supply
Toner density control ............... Automatic density mode and manual density mode selectable in 11
Memory (RAM) ........................ Main memory: 2 GB (Incl. page memory)
HDD......................................... e-STUDIO206L/256/306/356/456/506: 320 GB
Account Codes ........................ 10,000 codes
Department Codes .................. 1,000 codes
Warming-up time ..................... Normal start-up: Approx. 20 sec. (temperature: 20°C)
Power requirements ................ AC 110 V / 13.2 A, 115 V or 127 V / 12 A
* The acceptable value of each voltage is ±10%.
Power consumption................. 1.5 kW or less (115 V series, 200 V series)
* The electric power is supplied to the RADF, (ADU), Finisher, Job Separator, Offset Tray, PFP and
LCF through the equipment.
Total counter............................ Electronical counter
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Toner cartridge replacing method (There is a recovered toner
supply mechanism.)
steps
e-STUDIO207L/257/307/357/457/507: 320 GB
Start-up with hibernation: Approx. 20 sec. (temperature: 20°C)
220-240 V or 240 V / 8 A (50/60 Hz)
Super Sleep mode: 1.0 W or less (When the damp heater switch is set
to OFF, and only 1 FAX line is used)
Approx. 1.0 W (LAN connection, LAN connection and only 1 FAX line is
used)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
2 - 3
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
2