4.7
LASER OPTICAL UNIT <e-STUDIO206L/256/306/356/456/506>
4.7.1
Laser optical unit
(1)
Take off the rear cover.
P. 4-3 "4.1.6 Rear cover"
(2)
Disconnect 2 connectors from the LGC
board.
Notes:
Connect the flat harness to the LGC board
with its electrode side down. An error "CA20"
will be displayed if the connection is
incorrect.
(3)
Take off the inner tray.
P. 4-4 "4.1.9 Inner tray"
(4)
Disconnect 1 connector and remove 1 screw.
Take off the duct.
(5)
Remove 1 screw and take off the metal plate
cover [1].
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Fig. 4-165
Duct
Fig. 4-166
[1]
Fig. 4-167
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 58
Connector