General Operation; Overview Of Operation; Description Of Operation; Warming-Up - Toshiba e-STUDIO206L Service Manual

3.7

GENERAL OPERATION

3.7.1

Overview of Operation

Operation of equipment
3.7.2

Description of Operation

[ 1 ] Warming-up

1. Initialization
Power ON
 Heater lamp ON
 Set number "1" reproduction ratio "100%" and "WAIT WARMING UP" are displayed
 Fan motors ON
 Initialization of scanning system
- The carriage moves to the home position.
- The carriage moves to the peak detection position.
- The exposure lamp is turned ON.
- Peak detection (white color is detected by the shading correction plate)
- The exposure lamp is turned OFF.
 "READY (WARMING UP)" is displayed
2. Pre-running operation
The pre-running operation is started when the temperature of the fuser roller surface reaches a
certain temperature.
The main motor is turned ON.
- Fuser roller rotated
- Drum rotated
 Initialization of feeding system
- Each drawer tray goes up.
Pre-running operation stops after three seconds.
3. When the surface temperature of the fuser roller becomes sufficient for fusing,
"READY" is displayed.
[ 2 ] Ready state (ready for copying)
Buttons on the control panel enabled
When no button is pressed for a certain period of time,
- Set number "1" and reproduction ratio "100%" are displayed. Equipment returns to the normal
ready state.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
OUTLINE OF THE MACHINE
Operation during initializing, pre-running and ready
Drawer feed copying by [START] button
Bypass feed copying
Copying operation
Interrupt copying
3 - 30
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved