Adjustment Of Image Density - Toshiba e-STUDIO206L Service Manual

6.4.8

Adjustment of image density

The image density level can be set at the following codes.
Code
Text/
Text Photo
photo
7218-0 7219-0 7220-0
to 4 to 4 to 4
*1: e-STUDIO206L/256/306/356/456/506 only.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes back
to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Press the [FAX] button and then select an original mode. Then press the [START] button to
perform test copying.
(8) If the desired image density has not been attained, repeat step (2) to (7).
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
Item to be
Present
adjusted
ation
7221-0 Adjustment of
image density
to 4(*1)
6 - 28
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes
lighter.
Acceptable values: 0 to 10
Notes:
1.
Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
Ex.) When the image density level for
7218-0, 7218-1, 7218-2, 7218-3, and
7218-4 is assumed to be "A", "B", "C",
"D", and "E" respectively, they should
have the following correlation:
A B C D
2.
Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value is
changed from the default value.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
E