[ 6 ] Paper jam in saddle stitcher section
[EA80] Stapling jam
MJ-1032 / MJ-1033
Classification
Paper jam in saddle stitcher
section
Check item
Finisher
Stitcher home position switch
Parts to be replaced
Stitcher home position switch
Finisher controller PC board
[EA90] Door open jam
MJ-1106/1108
Classification
Paper jam in saddle stitcher
section
Check item
Finisher
Parts to be replaced
Sensor
Saddle stitcher controller PC
board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Stapling jam
•
Check if there is any paper in the finisher, saddle stitcher, or on
the transport path of the equipment, or on the stapling tray.
Remove it if there is.
•
Remove the staple cartridge from the finisher and remove
staples stuck in the stapling unit.
•
Check if the connector on the saddle stitcher controller PC board
is disconnected or the harnesses are open circuited. Correct if
any.
•
Check if the stitcher home position switches are working
properly.
Door open jam
•
Check if there is any paper in the finisher, saddle stitcher or on
the transport path of the equipment. Remove it if there is.
•
Check if the saddle stitcher door is closed.
•
Check if the connectors J10 and J11 on the saddle stitcher
controller PC board are disconnected from any of the cover
opening switches (the delivery cover sensor [P13] and the inlet
cover sensor [P19]) or the harnesses are open circuited. Correct
if any.
•
Check if the cover opening switches noted above are working
properly.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 104
Error content
Measures
Remark
Error content
Measures
Remark