Damp Heater Kit (Mf-5070U/E) Installation Procedure - Toshiba e-STUDIO206L Service Manual

4.18 Damp Heater Kit (MF-5070U/E) Installation Procedure

4.18.1 Preparation
Damp heater kit (check if all of the following parts are in it), tools
(a) Harness (for the scanner)
(b) Scanner damp heater
(c) Fuse board
(d) Fixing screw M3x8 (for the fuse board and
drum damp heater)
(e) Harness (for the scanner and drum)
(f) Harness (for the fuse board and
the switching regulator join)
(g) Harness (for the fuse board)
(h) Drum damp heater
Notes:
1. When installing the damp heater, ensure sufficient work space for disassembling the
equipment.
2. Turn the power of the equipment OFF and unplug the power cable before the installation.
3. Take off the Finisher (optional), the FAX unit, the Job separator (optional), Offset tray
(optional), or the Hole Punch Unit (optional) before starting the installation, if installed.
4. Be sure not to drop small parts such as screws into the equipment.
4.18.2 Procedure
(1) Remove 5 screws. Lift up the rear cover and
then release 3 hooks on the upper side.
Then open the upper side of the rear cover
slightly toward you, and then take off the rear
cover by lifting it up.
Remarks:
When installing the rear cover, hang the 3
hooks of the rear cover on the frame of the
equipment, and then hang the 3 hooks on
the holes of the upper rear cover to fix it.
Then tighten 5 screws to fix it securely.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
6
2
(b)
(a)
27
(e)
33
Rear cover
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 178
26
(c)
26
39
(f)
36
(g)
38
(h)
Fig. 4-509
Fig. 4-510
(d)
(d)