Adjusting Paper Exit Speed; Dip Switch Settings - Toshiba e-STUDIO206L Service Manual

6.16.4

Adjusting Paper Exit Speed

[ 1 ] Adjusting procedure
[ 1-1 ]

DIP switch settings

(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[1]
Fig.6-116
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
6 - 101
SW1
ON
1 2 3 4
SW1
SETTING / ADJUSTMENT
6