Paper Alignment At The Registration Roller - Toshiba e-STUDIO206L Service Manual

6.3.2

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Paper
Weight
type
Plain 64 - 80 g/m2
paper 17 - 20 lb. Bond
Thick 81 - 105g/m2
paper 1 21 - 28 lb. Bond
Thick 106 - 163g/m2
paper 2 29 lb. Bond - 90
lb. Index
Thick 164 - 209g/m2
paper 3 91 - 110 lb.
Index
OHP -
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
2. The adjustment of "Post card" is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
[0][5]
(Code) [START]
[Power]
[OK] or
[INTERRUPT]
Stores in memory
(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern
(2) Check if any transfer void is occurring. If
there is a transfer problem, try the values in
descending order as "31"  "30"  "29"···
until the transfer void disappears. At the
same time, confirm if any paper jam occurs.
Also, when the aligning amount has been
increased, this may increase the scraping
noise caused by the paper and the film sheet
as it is transported by the registration roller. If
this scraping noise is annoying, try to
decrease the value.
(3) Perform the same procedure for all paper sources.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
Upper Lower
drawer drawer
4100 (*1) 4101 (*1) 4108(*1)
4115 (*1) 4116 (*1) 4117 (*1)
- -
- -
- -
(Not necessary for LCF)
(Sub-code) [START]
[Drawer
selection]
6 - 6
PFP
PFP lower
upper LCF
drawer
drawer
4109 (*1) 4111
4118 (*1) 4119
- -
- -
- -
Current value
displayed
(*4) +[FAX]
(Test print)
Transfer void
Fig.6-8
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Bypass
ADU
feed
4110 4103
(*1) (*1)
4120 4104
(*1) (*1)
- - 4105
(*1)
- - 4106
(*2)
- - 4107
(*3)
Enter new
value
[POWER]
OFF/ON
(Exit)