Panasonic LP-V Series Operation And Maintenance Manual page 119

4.
Set [Delay Distance].
Input the distance from sensor for trigger to the starting
position of the marking using laser marker.
Here, set the distance to 60 mm.
5.
Set [Line Speed].
Here, set the speed to 0.060 m/min.
Sensor
Delay distance
Notice
• Fine-adjust the delay distance by executing the test marking actually.
Reference
• When the line speed fluctuates, use [Encoder signal]. In such case, enter the number of encoder pulses. When the
encoder is not used, marking on flying objects is executed by applying the calculation result based on the line speed
already input.
For the encoder signal, refer to "Trigger Selection" (P.221).
Work direction
Delay distance
ME-LP400V-OP-6
Sensor
Work direction
119