Panasonic LP-V Series Operation And Maintenance Manual page 221

⿎ Trigger Selection
Sets the timing of marking start.
• Trigger Marking
• Equidistant Marking
(1) Trigger Marking
Starts marking to flying object per marking trigger. Setting parameters vary depending on whether the encoder is used or
not.
When the encoder is not used
(Encoder signal: invalid)
1
2
3
Description
1 Delay Distance
Inputs the moving distance of line from trigger input to the
start of marking.
Setting Range
Reference
• Set a delay distance shorter than the distance between the
workpieces.
• When the next trigger signal is inputted during delay, warning
(E800) occurs. (Only if "Detect TRIG. Warning during Marking"
in Environment Setting is valid.)
2 Line Speed
Inputs the line speed. Available when encoder setting is disabled.
Setting Range
3 Encoder Signal
Enable this function when using the encoder. The setting parameter for the line speed is disappeared from the
screen and the parameter for encoder pulse number appears instead when pressing the box.
When the encoder is
not used
When the encoder is
used
: Starts the marking per marking trigger.
: Repeats marking with the interval specified while the marking trigger is turned to ON.
5
0 to 500.00 mm
to
0.060 240.000 m/min
to
0.060 170.000 m/min
to
0.060 120.000 m/min
to
0.060 85.000 m/min
: Performs marking to flying object by applying the calculated line speed already input.
: Performs marking to flying object by applying the calculated line speed which is derived
from the pulse sent from the encoder input to the input terminal.
When the encoder is used
(Encoder signal: valid)
1
3
4
Delay distance
(LP-430 / LP-420 / LP-435 / LP-425 / LP-V10 / LP-V15)
(LP-410)
(LP-431 / LP-421 / LP-W052)
(LP-411)
ME-LP400V-OP-6
5
Sensor
Work direction
221