Maintenance; I/O Check Monitor - Panasonic LP-V Series Operation And Maintenance Manual

4-5 Maintenance

In the Maintenance screen, the following status of the laser marker are displayed.
• On/off status of I/O terminals
• Error log of the laser marker

4-5-1 I/O Check Monitor

The ON / OFF status of the I/O signals and DIP switch can be confirmed on this screen.
When the signal is ON status: "1" is displayed.
When the signal is OFF status: "0" is displayed.
Description
1 I/O Terminal Monitor:
Enables to check the ON/OFF state of the input and output terminal.
2 I/O Connector Monitor:
Monitors the ON/OFF state of I/O connector.
3 DIP Switch Monitor:
Monitors the ON/OFF state of DIP switch.
Notice
• The signals represented by "RESERVE" are prepared for "system reserved". Do not connect anything. (The status is
displayed with "-".)
Reference
• The I/O monitor updates the I/O state every 20 ms. Note that the I/O monitor in remote status updates every 200 ms.
• The name of each signal may vary depending on laser marker model. Refer to "External Control Manual".
• When the setting value of the one-shot output time is short, it might not update on I/O check monitor. To check the
update status of the one-shot output on the I/O check monitor, set larger value to the one-shot output time. Refer to "4-
16-3 Communication, I/O Setting (Environment 3)" (P.261).
1
3
ME-LP400V-OP-6
2
133