Replacement Of Fuse; Replacement Of Cable - Panasonic LP-V Series Operation And Maintenance Manual

Replacement of fuse

Replace fuse of the controller when blowing.
The power of the laser marker cannot be turned on if the fuse is blown.
⿎ Models of replacement parts
Depending on the manufactured period of the laser marker, the available parts model of the fuse is vary. Check the ampere
rating printed on the fuse holder part of the controller rear side and select the appropriate model form this table. If the user
applies any other fuses than the specified one, failure might result.
Applicable laser marker
LP-400 series
LP-V series
LP-W series
⿎ Steps for replacement
1.
Remove causes for fuse blowing.
2.
Turn OFF the key switch of the controller, and disconnect the controller power cable.
3.
Turn the fuse holder on the back side, and remove the
fuse.
4.
Replace it with new one.
5.
Turn the fuse holder, and install the fuse.

Replacement of cable

If the cable connecting the head and controller is broken because of the usage conditions and installation environment, it
needs to be replaced.
⿎ Models of replacement parts
For details of purchasing cables, contact our sales office.
Type
Head Power Cable
Head Control Cable
⿎ Steps for replacement
Refer to Operation/Maintenance Manual "2-2 Connecting Laser Marker" (P.72), and connect cables.
286
Type
Time Lag Fuse (Rating: 250V 10A)
Type A of PSE (Rating: 250V 15A)
Time Lag Fuse (Rating: 250V 6.3A)
B Type Brown Glass Fuse (Rating:
250V 15A)
Model
LP-ACP20-5
LP-ACS20-5
ME-LP400V-OP-6
Model
0215010
(made by Littelfuse)
GAB 250V 15
(made by Daito Communication Apparatus Co., Ltd)
021506.3MXP (made by Littelfuse)
FGBO 250V15APBF (made by FUJI TERMINAL
INDUSTRIES Co., LTD)
LP-400 Series LP-V/LP-W Series
Fuse Holder