Panasonic LP-V Series Operation And Maintenance Manual page 189

Description
5 Laser Power Correction :
Scan Speed Correction :
Laser Pulse Cycle Correction (Only LP-V series) :
Correction of each bar code No. for the laser power / scan speed / laser pulse cycle set at laser setting.
Setting Range of Laser Power Correction
Setting Range of Scan Speed Correction
Setting Range of Laser Pulse Cycle Correction
Reference
• These settings are not applied to the human readable text of the code symbol. For the laser setting of the human
readable text, refer to "Human Readable Text" (P.203).
• For the composite code, correction of the laser power, scan speed and laser pulse cycle are set separately in 1D and
2D symbols.
• If the value of "Laser power correction" × "laser power" is equal to or larger than 100, the setting will be "100".
• Marking is not available when the laser power correction value is "0".
• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.
6 Area No. :
Displayed when marking on-the-fly is set in "Trigger setting".
It indicates the order of the marking field for the concatenated marking to flying object.
Setting Range 0 to 15
7 Whole width or Whole size:
Displays the entire size of the code, including the quiet zone corresponding to the data specified.
For the 2D code, the size with the margin or quiet zone is indicated in ( ).
8 Code Data :
Specifies the data to encode. Press the target line and press [EDIT] to display the data input screen.
Set the data character specified in "Code Type and Code Data" (P.190).
Reference
• Check the digit number of function characters before inputting the current date, expiry date, counter, lot, rank, and
serial data function characters in the code data.
• The code data are automatically converted to the one-byte or two-byte characters depending on the applicable
character type of the selected code type regardless the input character type.
• When the code data is set in the several strings, they are connected together without linefeed to create the code data.
Reference
• The marking pitch of the bar code is set at "Laser Condition." Refer to "4-11 Laser Setting" (P.214). It is recommended that
the marking pitch for laser setting should be specified so that it should be an integral multiple of half line width of solid
line. If the space is generated on the marked object, set the marking pitch with small value.
0 to 200%
5 to 500%
50 to 200%
ME-LP400V-OP-6
189