Panasonic LP-V Series Operation And Maintenance Manual page 226

⿎ Concatenated Marking Setting
The setting method for marking the character to the work whose length exceeds the marking field is described here.
Setting Method
If the length of the character string to be marked to a flying object exceeds the marking field, divide the characters into the
length "marking field × 2/3", and allocate them to each marking field as shown in the figure below.
Marking starts
Character Setting
Marking condition
Reference
• At the marking to flying object with an encoder, the marking stops for each area when the line stops and then enters
the wait state of the encoder pulse input.
• 16 marking fields (Area No. 0 to 15) can be used.
• Specify the character setting so that the last character in the character string should match with or go over the
projection line on the marking image screen. The projection line on the marking image screen indicates × 2/3 of
marking field (starting of the next marking field). (There may be the cases that the characters set outside of the guide
line (the characters in the upstream of moving direction) cannot be marked during low-speed operation.)
226
Moving direction of flying object
Marking field × 2/3
1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J K L M N
Area No.: 0
• Set the characters "1 to 6" to the first line.
• Set the characters "7 to B" to the second line.
• Set the characters "C to G" to the third line.
• Set the characters "H to L" to the fourth line.
• Set the characters "M and N" to the fifth line.
• Condition No. 1: Area No. 0. Set the marking condition of "1 to 6".
• Condition No. 2: Area No. 1. Set the marking condition of "7 to B".
• Condition No. 3: Area No. 2. Set the marking condition of "C to G".
• Condition No. 4: Area No. 3. Set the marking condition of "H to L".
• Condition No. 5: Area No. 4. Set the marking condition of "M and N".
Area No.: 3
Area No.: 2
Area No.: 1
ME-LP400V-OP-6
Area No.: 4