Setup And Connect The Laser Marker - Panasonic LP-V Series Operation And Maintenance Manual

3-2-1 Setup and connect the laser marker

Reference
• For the installation and connecting, refer to "2-1 Installation" (P.59) and "2-2 Connecting Laser Marker" (P.72).
1.
Install the laser marker ensuring the following points.
• Take laser protection measures required to use Class 4 laser products.
• Please avoid vibration and install in a place without any shocks.
• For the proper cooling performance, install not to bar the flow of air.
2.
Connect the head and controller of the laser marker using these cables.
• Head control cable
• Head power cable
• Fiber cable *1
3.
Connect the following devices and cables to the controller.
• Touch panel console and return harness, or monitor and mouse, or PC
• I/O terminal *2
4.
Connect the controller power cable.
*1 : Only for LP-V and LP-W series. The fiber cable cannot be detached from the device.
*2 : Wire the each terminals depending on the control method.
* Place a protective enclosure in the range of laser radiation for actual use.
ME-LP400V-OP-6
81