Lasing Position Check - Panasonic LP-V Series Operation And Maintenance Manual

2-1-7 Lasing position check

Notice
• Use the dual pointer and guide laser only as the guideline. For obtaining the appropriate marking position and quality,
fine adjust the work position and distance after marking on an actual work.
⿎ Dual Pointer Function
Dual pointer shows the rough indication of the work distance (distance from the head base to the marking surface). It
displays the red point emitted in oblique and the red cross emitted perpendicularly from the head. The distance where the
laser point is closest to the center of the cross represents the guide of the work distance.
Depending on the required marking quality or installation condition including the focus adjustment usage, the dual pointer
may shows not always the appropriate work distance. Confirm the marking quality with the work distance indicated by the
dual pointer and adjust it accurately as appropriate.
Refer to "4-6-1 Dual pointer" (P.136) for details.
LP-400 Series
⿎ Guide Laser Function
The marking contents and marking field can be traced with the red guide laser. By using the guide laser function, the
position and contents of the marking can be checked visually.
Refer to "4-6-2 Guide laser" (P.137) for the using method.
LP-400 Series
Reference
• The guide indication is stopped automatically after passing 1 minute from start-up.
• The dual pointer is adjusted according to the distance from the work defined at the factory. When the work distance is
changed by the focus adjustment function, dual pointer does not move with this function, so it cannot be used as the
work distance guide.
LP-V/LP-W Series
Where the red point is closest to
the center of the cross is the rough
indication of the work distance.
LP-V/LP-W Series
ME-LP400V-OP-6
69