Panasonic LP-V Series Operation And Maintenance Manual page 218

Description
4 Jump (Jump adjustment) :
Adjusts the waiting time for starting radiation at the start point of the line.
It is applied only to the lines which distance to the next line is long.
Setting a large value improves the disordered lines at the start points.
Setting a larger value makes the marking time longer.
Setting Range
Initial Value
5 Pre-scan Time :
The pre-scan time adjusts the start-up and fall times of the laser beam at the start/end points. Setting the scanning
period improves the too thick marking at the start/end points.
Setting larger value makes the marking time longer.
Setting Range
Initial Value
6 Point Rad. On/Off (Point Radiation ON/OFF Adjustment) :
Adjusts the on/off timing of the radiation for "4-10-6 Point Radiation Condition" (P.212).
On time specifies the waiting time for starting radiation.
Off time specifies the waiting time for moving to the next radiation points.
Setting a larger value makes the marking time longer.
Setting Range
Initial Value
7 Laser Frequency (LP-400 series only) :
Selects the frequency of laser from 5, 10 or 20 kHz. Setting a small value is likely to make the line dotted at the
high-speed scanning.
Setting Range
Initial Value
218
0 to 100
0
0.00 to 10.00 ms
0.00 ms
0.00 to 9.99 ms
0.00 ms
5kHz, 10kHz, 20kHz
20kHz
ME-LP400V-OP-6