Brother BAS H Series Instruction Manual page 102

CHAPTER 4 EXTENDED OPTION OUTPUT (PROGRAM)
 Individually programming on and off
In the examples of " Turning the output interlocking on and off corresponding to sewing machine operations" and
"Modifying data you programmed once", a procedure was described outlining how to create a program to keep the
output on state for a time set for Timer 2, and return it to the off state automatically.
In this example, create a program to automatically open the left work clamp at the sewing start point (option output No.
15 ON) and close it simultaneously when the machine starts. (option output NO. 15 OFF). Confirm that on and off
output conditions are different.
1. Have the programmer at hand and display the output settings.
2. Referring to the table of sewing machine operation mode condition numbers (refer to page 85), set "ON when
condition No. 2 is established (on completion of movement to the sewing start point)".
On the setting screen, make the following settings.
3. Referring to the "Mode for operating the sewing machine" table of condition numbers (refer to page 85), set to "off
when condition No. 3 (before sewing start) is established".
Enter into the setting screen as shown below.
4. Touch to save the extended option output.
5. Display the extended option output settings once more, and then touch
which was saved in step 4 to the sewing machine.
6. Carry out sewing operation. Confirm that the left work clamp rises after the needle returns to the sewing start point
and it lowers when sewing begins.
As shown in the above example, when Timer 2 is set to [0000], the on or off state will remain unchanged after the
condition is established.
94
BAS H series, Programmer
to apply the extended option output