Resizing A Pattern - Brother BAS H Series Instruction Manual

Resizing a pattern

The following describes how to resize a programmed pattern.
The reference point for resizing patterns is the center point for enlarging or reducing the pattern size.
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
4. Use to select the pattern which you would
like to resize.
5. When you press the
change to red lines and it will be selected.
6. Touch and enter the resizing ratios for the
X direction and Y direction.
Example: To enlarge by 150%: Change the resize
setting to "150.0%".
Reference point (origin)
key once, the pattern will
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
7. Touch to set the resize center.
Example: To resize centering on the origin: Set the
resize center to "Origin".
8. Touch to set the hold element.
Example: To resize while maintaining the same
number of stitches as in the original data: Set the
hold element to "Keep Number of Stitches".
9. Press .
The pattern will be resized.
* If the resize center was set to "Specified point" in
step 7, you can use the jog key to move the
cursor so that the outline can be resized with
the current cursor position as the resize center.
In this case, after moving the cursor
once more.
In addition, each time you change the resize ratio,
the preview is displayed after the outline is
resized.
10. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
, press
61