CHAPTER 3 PROGRAMMING PATTERNS
Moving the sewing start point
The following describes how to move the sewing start point from 1 to 1'.
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch
.
3. Touch
.
4. Touch
to select "Manual select".
5. Use
to move the cursor
*You can move the cursor according to the skipping
units.
* You can move the cursor continuously by holding
down the key.
6. When you press the
will change to red and it will be selected.
64
to 1.
key once, the sewing point
BAS H series, Programmer
7. Press
.
8. Use the jog key to move the cursor
9. Press
.
The 1 at the white circle for the 1st stitch will move,
and the needle position for the sewing start point
will move to 1'.
10. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
to 1'.