Moving A Part Of A Continuous Program In Parallel - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Moving a part of a continuous program in parallel

This section describes how to move part of a continuous program (patterns B and C) in parallel at the same time, using
an actual program as an example.
Feed
Pattern B
Pattern A
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
4. Use to position the cursor
of pattern B.
5. When you press the
change to red lines and it will be selected.
72
Pattern C
at the outline
key once, the outline will
BAS H series, Programmer
6. Repeat steps 4 and 5 to select pattern C as well.
Patterns B and C will now be selected.
7. Press .
8. Use the jog key to move the cursor
9. Press .
Pattern B will move to 2, and the pattern C will move
to 4 in the same way.
10. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
to 2.