Changing The Attributes Of Sewing Points - Brother BAS H Series Instruction Manual

Changing the attributes of sewing points

1. .
Touch
2. .
Touch
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
■Selecting continuous sewing points for editing
4. Touch to set the selection method to
"Range select".
5. Use to move the cursor
for the range that you would like to select.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor
of the range that you would like to select. The
sewing points will change to red, and the points from
the start point to the end point will be selected.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
8. Touch to set the attribute (Stitch, Feed,
Baste).
9. Press .
■ Manually selecting component points for
4. Touch
5. Use
6. When you press the
Skipping units
Code display
switching
7. If there is more than one attribute that you would
Selection method
Attributes
to the start point
8. Touch
9. Press
to the end point
* When switching from "Feed" to "Stitch" or from "Baste" to
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
editing
to set the selection method to
"Manual select".
to move the cursor
point that you would like to move.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
will change to red and it will be selected.
When you press the
sewing point will be unselected.
like to change, repeat steps 5 and 6.
To select all outlines
*
Hold down to select all sewing points in an
outline.
* To unselect all outlines
Hold down to unselect all selected sewing
points.
to set the attribute (Stitch, Feed,
Baste).
.
"Stitch", the sewing pitch must be 12.7 mm or less (for the
BAS-360H, BAS-365H, BAS-370H and BAS-375H, 20.0
mm or less) for both X and Y. If the setting is outside the
range, the buzzer will sound twice and processing will stop.
to the sewing
key once, the sewing point
key once, the selected
45