Copying An Outline Symmetrically - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Copying an outline symmetrically

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to copy symmetrically.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
copy symmetrically, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
32
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
6. Touch to set the symmetry mode and
method for moving the cursor (Move freely, Snap to
needle point)
* Symmetry mode
... X-axis, Y-axis, Center of Mask (horizontal),
Center of Mask (vertical), Mask top edge, Mask
bottom edge, Mask left edge, Mask right edge,
Specified axis
* The method for moving the cursor is set only when
the symmetry mode is set to "Specified axis".
7. Press .
* If the symmetry mode was set to "Specified axis"
in step 6, you can use the jog key to move the
cursor so that the current cursor position
moves symmetrically around the center.
In this case, after moving the cursor
once more. When this is done, each time
you change the cursor position, the preview is
displayed after the cursor is moved.
Symmetry
mode
, press