Checking Programs; Checking Each Stitch; Moving To The Start Position - Brother BAS H Series Instruction Manual

This section describes the icons which are used when checking programs and how to use them.

Checking each stitch

1. .
Touch
2. Touch to set the skipping units (1, 10, 50, 100, 500, 1000, 5000) and code display switching (Hide code,
Show code).
*
Refer to the "List of code settings" (page 48) for a list of the codes which are displayed when code display switching is set to
"Show code".
3. Touch or
* To move backward
Touch , or use
Hold down or
* To move forward
Touch , or use
Hold down or

Moving to the start position

1. .
Touch
2. .
Touch
The feed will return to the sewing start position.
C h e c k
C h e c k
Skipping units
Code display
switching
. (Or, operation is also possible using
.
. The cursor will move back by the skipping units while the key is being pressed.
.
. The cursor will move forward by the skipping units while the key is being pressed.
BAS H series, Programmer
i n g p r o g r a m s
i n g p r o g r a m s
.)
CHAPTER 3 PROGRAMMING PATTERNS
49