CHAPTER 3 PROGRAMMING PATTERNS
Separating an outline at a sewing point
When separating outlines at sewing points when the outlines contain component point data, the
*
component point data will be lost.
1.
.
Touch
2.
.
Touch
Setting bar tacking at a sewing point
1.
.
Touch
2.
Touch
3. Touch
to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
4. Use
to move the cursor
point where you would like to set backtacking.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
46
3. Touch
4. Use
* You can move the cursor continuously by holding down
5. Press
5. Touch
* You cannot set backtacking to cross from one outline to
Skipping units
Code display
switching
6. Press
to the sewing
* Backtacking will be set in the return direction from the
current sewing point.
BAS H series, Programmer
to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
to move the cursor
point in the outline where you would like to
separate the outline.
the key.
.
the key.
to set the number of backtack
operations (1 to 9) and the number of backtack
stitches (1 to 9).
another, or set it at the sewing start point.
If you would like to set backtacking at the sewing start
point, refer to "Adding and deleting backtack stitches
for an outline" on page 35.
.
Skipping units
Code display
switching
to the sewing
No. of backtack
operations
No. of backtack
stitches