Zigzag Stitch - Brother BAS H Series Instruction Manual

Zigzag stitch

This section describes how to program a zigzag stitch which moves to the left and right while centered on the sewing
start point (A), using an actual program as an example.
Two types of zigzag sewing can be selected: V-type zigzag and N-type zigzag. The left and right zigzag widths can also
be set separately for each type. In addition, zigzag stitches with curved lines can also be programmed.
(A description of the programming method using V-type zigzag sewing is given as an example.)
Zigzag width (right)
Zigzag width (left)
Pitch
1. Carry out steps 1 to 3 in "Programming procedure"
(page 17).
2. Touch .
3. Touch .
* To program curved-line zigzag stitches,
touch .
4. Touch to change to "V-type zigzag".
5. Set the running pitch and zigzag width for V-type
zigzag stitches.
Example: To set the running pitch to 3.0 mm:
Touch to set the running pitch to
"03.0mm".
6. Set the zigzag width (right) for V-type zigzag
stitches.
Example: To set the zigzag width (right) to 1.0
mm: Touch
(right) to "01.0mm".
7. Set the zigzag width (left) for V-type zigzag
stitches.
Example: To set the zigzag width (left) to 1.0 mm:
Touch
to "01.0mm".
8. Set the number of zigzags for V-type zigzag
stitches.
Example: To set the number of zigzag stitches to 2:
Touch
to "2".
9. Use the jog key to move the cursor
10. Press
* To program curved-line zigzag stitches, repeat this
procedure.
11. Carry out steps 5 and after in "Programming
procedure" (page 18).
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
to set the zigzag width
to set the zigzag width (left)
to set the number of zigzags
twice.
to B.
59