Resizing An Outline - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Resizing an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to resize.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
resize, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
34
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
6. Touch to set the X ratio, Y ratio, resize
center, hold element (stitch number or sewing pitch)
and method for moving the cursor (Move freely, Snap
to needle point).
* Resize center ... Origin, Center of Mask, Mask top
edge, Mask bottom edge, Mask top-left, Mask
bottom-left, Mask top-right, Mask bottom-right,
Specified point
* The method for moving the cursor is set only when
the resize center is set to "Specified point".
7. Press .
* If the resize center was set to "Specified point" in
step 6, you can use the jog key to move the cursor
so that the outline is resized with the current
cursor position as the resize center.
In this case, after moving the cursor
once more. In addition, each time you change
the X ratio or Y ratio, the preview is displayed after
the outline is resized.
* Outlines which consist of stitches/feeding/basting
and outlines which have been loaded from *.SEW
files normally have "Keep Number of Stitches" as
their hold element.
X ratio
Y ratio
Resize center
Hold element (stitch
number or sewing
pitch)
, press