Switching The Sewing Start And End Points For Outlines; Changing The Connection Method For Outlines - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Switching the sewing start and end points for outlines

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to switch the outline start point
or end point for.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.

Changing the connection method for outlines

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to change the outline
connection method for.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
36
at the outline
key once, the outline will
key once, the selected
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
5. If there is more than one outline that you would like to
switch the start point or end point for, repeat steps 3
and 4.
To select all outlines
*
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Press .
When multiple continuous outlines are selected, the
*
orders are also switched.
Example: When outlines 1, 2, 3 and 4 have been
created, and you select outlines 1, 2 and 4 (red
lines) and switch the start and end points:
Feed
1 2
Start point
The sewing order becomes 1', 2', 3, 4'.
(The start and end point for 1', 2' and 4' are reversed.)
Start point
Feed
1'
2'
Feed
5. If there is more than one outline that you would like to
change the outline connection method for, repeat steps
3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Touch to set the outline connection method
(Stitch, Feed, Running, Baste).
* If "Stitch" is set as the outline connection method:
If the maximum pitch of the stitches exceeds 12.7 mm
(for the BAS-360H, BAS-365H, BAS-370H and
BAS-375H, if it exceeds 20.0 mm), use the "Feed"
setting to connect.
* If "Running" is set as the outline connection method:
The outline is connected by a straight line at the
current outline running pitch.
7. Press .
* The end point of the previous outline and the start
Feed
Feed
4
3
End point
End point
4'
3
Feed
Outline connection
method