Table of Contents
Advertisement
CHAPTER 4 EXTENDED OPTION OUTPUT (PROGRAM)
On the precondition that a checking board is created, this section describes how to create programs by providing some
examples.
Necessary items (other than for Basics)
Checking board (refer to "Reference material" pages 107 - 108.)
Limitations of extended option output
・If the number of output points exceeds 20 (24 for the BAS-360H, BAS-365H, BAS-370H and BAS-375H) (including
work clamp output, etc.)
・If the number of output points exceeds 14 (16 for the BAS-360H, BAS-365H, BAS-370H and BAS-375H)
・Input check during sewing machine operation is disabled. Therefore, on and off operation of the output detected by
input from the foot switch pedal while sewing is not possible.
・Sequence output during sewing machine operation is disabled.
On and off operation of the output by inputting trigger data out of sewing data is enabled.
Temporarily pausing the sewing machine to run the extended option output by inputting trigger data is enabled. (Input
and output are enabled in this case.)
・Disabled when many AND conditions are set. For example, operation by switching among multiple modes and
inhibition of output by combining multiple inputs are disabled.
Up to 2 input AND conditions can be set for each option output. Configuration of 3 input AND conditions is enabled
by setting one output as a virtual output. (Refer to "Examples of option outputs" on page 92, 99.)
・Control of the incorporated stepper motor output by the extended option output is disabled.
98
U
s
e
o
f
e
x
t
e
n
d
e
d
o
p
U
s
e
o
f
e
x
t
e
n
d
e
d
o
p
BAS H series, Programmer
t
i
o
n
o
u
t
p
u
t
(
A
p
p
l
i
t
i
o
n
o
u
t
p
u
t
(
A
p
p
l
i
c
a
t
i
o
n
)
c
a
t
i
o
n
)
- Quick Links:
- Contents and Usage
- Part Names and Functions
Hide quick links:
Advertisement
Table of Contents
