Adding And Deleting Codes At Sewing Points; Editing End Codes - Brother BAS H Series Instruction Manual

Adding and deleting codes at sewing points

1. .
Touch
2. .
Touch
3. Use to move the cursor
point where you would like to add or delete a code.
* You can move the cursor continuously by holding down
the key.
4. Touch the place where you would like to add or
delete a code. The code will be added or deleted.

Editing end codes

1. .
Touch
2. .
Touch
3. Touch the end code that you would like to change.
The end code for the final sewing point will be
changed.
to the sewing
If you touch the icons at the top of the screen, you
5.
can check the setting details for the codes.
Sewing points which have a code set will change to
*
green.
* For details on the codes that can be set, refer to "5.
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
* Depending on the type of code, the selection of codes
for adding and deleting may take place in the screen
destination.
To return to the previous screen, touch
*
Refer to "List of code settings" (page 48) for a list of
the codes which can be set.
* After touching the code, you can hold down the
keys to move the cursor
or next applicable point when a code is inserted. The
cursor will move in a straight line from the current
point to the applicable point.
Editing end codes" in the programming procedures
(page 18).
.
to the previous
47