Editing Programs (Editing Outlines); Deleting An Outline; Moving An Outline - Brother BAS H Series Instruction Manual

The procedure for editing programs using icons is as follows.

Deleting an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to delete.

Moving an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to move.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
E d i t i n g p r o g r a m
E d i t i n g p r o g r a m
at the outline
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
s ( E d i t i n g o u t l i n e s
s ( E d i t i n g o u t l i n e s
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
delete, repeat steps 3 and 4.
* To select all outlines
Hold down
* To unselect all outlines
Hold down
6. Press .
5. If there is more than one outline that you would like to
move, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Press .
7. Touch to set the method for moving the cursor
(Move freely, Snap to needle point).
8. Use the jog key to move the cursor
where you would like to move the outline.
9. Press .
)
)
key once, the outline will
key once, the selected
to select all outlines.
to unselect all selected outlines.
Method for moving the
cursor
to the place
29