Moving A Sewing Point - Brother BAS H Series Instruction Manual

Moving a sewing point

1. .
Touch
2. .
Touch
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000), code display switching (Hide
code, Show code) and method for moving the cursor
(Move freely, Snap to needle point).
* If the method for moving the cursor is set to "Move
freely", the cursor can be moved to any desired position.
* If the method for moving the cursor is set to "Snap to
needle point", the cursor will move to the sewing point.
■ Selecting continuous sewing points for editing
4. Touch to set the selection method to "Range
select".
5. Use to move the cursor
for the range that you would like to select.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor
of the range that you would like to select. The sewing
points will change to red, and the points from the start
point to the end point will be selected.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
8. Press
the cursor
move the component point.
9. Press
■ Manually selecting component points for
4. Touch
"Manual select".
Skipping units
Code display
switching
Selection method
5. Use
Method for
point that you would like to move.
moving the cursor
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
6. When you press the
will change to red and it will be selected.
When you press the
sewing point will be unselected.
Skipping units
7. If there is more than one sewing point that you would
Code display
like to move, repeat steps 5 and 6.
switching
Selection method
*
Method for
moving the cursor
to the start point
* To unselect all outlines
8. Press
the cursor
to the end point
move the component point.
9. Press
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
once, and then use the jog key to move
to the place where you would like to
.
editing
to set the selection method to
to move the cursor
the key.
key once, the sewing point
To select all outlines
Hold down to select all sewing points in an
outline.
Hold down to unselect all selected sewing
points.
once, and then use the jog key to move
to the place where you would like to
.
Skipping units
Code display
switching
Selection method
Method for
moving the cursor
to the sewing
key once, the selected
43