Modifying a pattern by deleting a component point
This section describes how to delete outline component points from a pattern which has already been programmed.
This section describes how to modify a pattern by deleting component point D, using the following program as an
example.
A
B
1. Carry out step 8 in "Programming procedure"
(page 20).
2. Touch
.
3. Touch
.
C
A
D
B
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
C
Use
to move the cursor
4.
You can move the cursor continuously by
*
holding down the key.
5. When you press the
point will change to red and it will be selected.
6. Press
.
The selected component point will be deleted. The
outline will be reconstructed so that the component
points before and after the selected component
point are joined together.
7. Carry out steps 6 and 7 in "Programming
procedure" (page 19, 20).
to D.
key once, the component
69