Changing The Attributes Of Outline Component; Points; Separating An Outline At A Component Point - Brother BAS H Series Instruction Manual

Changing the attributes of outline component points
1. .
Touch
2. .
Touch
3. Use to move the cursor
component point that you would like to change the
attributes for.
* You can move the cursor continuously by holding down
the key.

Separating an outline at a component point

1. .
Touch
2. .
Touch
3. Use to move the cursor
component point in the outline where you would
like to separate the outline.
* You can move the cursor continuously by holding down
the key.
4. Touch
Curve) to change. The attribute of the component
point will then be changed.
* You cannot change the attributes for component
points in circles (circles specified by radius,
circles specified by diameter, circles specified by
three points) and ellipses.
* It is possible to change arcs into straight lines or
to the curves, but straight lines and curves cannot be
changed into arcs.
4. Press
* Circles (circles specified by radius, circles specified
by diameter, circles specified by three points),
ellipses
stitches/feeding/basting cannot be separated.
* The outline will be separate at the position of the
selected component point.
Example: To separate outline 1 at component point A
to the
Select component point A
Start point
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
to select the attribute (Straight line,
.
and outlines which
Outline will separate into 1'
and 2' at component point A
End point Start point
Outline 1
Change attributes
consist of
End point
1'
2'
41