Combining Outlines; Changing The Sewing Order For An Outline - Brother BAS H Series Instruction Manual

point of the current outline are connected.

Combining outlines

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to combine.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.

Changing the sewing order for an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to change the outline sewing
order for.
4. When you press the
change to red lines and it will be selected.
When you press the
at an outline
key once, the outline will
key once, the selected
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
5. If there is more than one outline that you would like
to combine, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Press .
* The following outlines cannot be combined.
・Closed outlines (circles specified by radius, circles
specified by diameter, circles specified by three
points, ellipses, rectangles, etc.)
・Outlines which consist of stitches/feeding/basting
and other types of outlines
* If only one outline is selected, it will become a closed
outline.
<Example>
End
point
Start point
outline will be unselected.
5. If there is more than one outline that you would like
to change the outline sewing order for, repeat steps
3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Touch to set the sewing order (Move
Forward, Move Back, Move to start, Move to end).
.
7 Press .
Start and end points
Sewing order
37