Adding An Escape Point Before The Sewing Start Point - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Adding an escape point before the sewing start point

The following describes how to set the escape point A before the sewing start point.
* The escape point is a provisional point provided to preventing the work clamp from interfering with the needle or the presser foot
when the work clamp is lifted at the start point.
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
66
4. Use the jog key to move the cursor
5. Press
The sewing start point at position 1 will be moved to
position A. By shifting the position of the sewing
start point, the point can be used as an escape point.
6. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20
BAS H series, Programmer
.
).
to A.