Modifying A Pattern By Adding A Component Point - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Modifying a pattern by adding a component point

This section describes how to add outline component points to a pattern which has already been programmed.
This section describes how to modify a pattern by adding component point A' and adjusting the positions of A and A',
using an actual program as an example.
C
A B
1. Carry out step 8 in "Programming procedure"
(page 20).
2. Touch .
3. Touch .
4. Use to move the cursor
5. Press .
* You can move the cursor continuously by
holding down the key.
A component point A' will be added to the outline
between component points A and B.
A A' B
68
D
A
to A.
D
C
BAS H series, Programmer
C D
B
A'
6. Touch .
7. Touch
8. Use
* You can move the cursor continuously by
holding down the key.
9. When you press the
point will change to red and it will be selected.
10. Press .
11. Use the jog key to move the cursor
12. Press .
13. Repeat steps 8 to 11 to move component point A'
which was added in step 5.
A
A'
14. Carry out steps 6 and 7 in "Programming
procedure" (page 19, 20).
to select "Manual select".
to move the cursor to A.
key once, the component
to A.
C
D
B