Creating an arc
1. Touch
.
2. Touch
.
Creating a rectangle
1. Touch
.
2. Touch
.
3. Make the settings for each item.
* Refer to "Setting parameters" (page 27) for details
on the setting method.
3. Make the settings for each item.
* Refer to "Setting parameters" (page 27) for details
on the setting method.
4. Use the jog key to move the cursor
point, and then press
5. Use the jog key to move the cursor
point, and then press
* If you would like to create more than three points
for the arc, you can continue entering more
points.
4. Use the jog key to move the cursor
point, and then press
Second point
5. Use the jog key to set the rectangle shape.
To create the rectangle shape, move the cursor
from the single side which was created in step 4 to
the desired position for the rectangle, and then press
.
Second point
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
to the second
.
.
to the second
.
Start point
Start point
to the third
23