Siemens Sinumerik 840D Operating Turning page 208

Hide thumbs Also See for Sinumerik 840D:

Measuring the workpiece zero

Vertical softkey bar

Display area

By pressing the VSK 2 "Work offset" the input mask

"Work offset" will be selected.

See module B523 - "Operating area "Parameter"".

By pressing the VSK 7 „Set WO" the chosen work

offset values are accepted.

By pressing the VSK 8 "Back" you switch back to

the main screen of the Sinumerik Operate.

Measuring the workpiece with "Set edge"

5.3.1 Parameters for "Set edge"

Measuring only

Work offsets:

Select "Work offset" and a corresponding off-

set value (G54...G57),

choose "Measuring only" if the measured val-

ues should only be shown.

Alternative parameter selection. Several

Work offsets are possible.

Note the machine manufacturer„s documen-

Reference point.

840D/828D SINUMERIK Operate

Sinumerik 828d