Siemens Sinumerik 840D Operating Turning page 605

Complex programming example
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (FINISHING_TOOL_35) in the
tool list with the orange selection cursor and press
the VSK 1 "To program".
Confirm your inputs by pressing the VSK 8 "Accept".
The following programm block is inserted into the
program:
15. Insert a thread cycle into the program.
Press the VSK 4 "Thread".
The work area for the technology "Thread" opens.
Press the VSK 3 "Thread long." to open the parame-
ter mask for the Cycle "Thread longitudinal".
16. Fill out the parameter mask as follows:
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (THREADING_TOOL_2) in the
tool list with the orange selection cursor and press
the VSK 1 "To program".
Confirm your inputs by pressing the VSK 8 „Accept".
The following programm block is inserted into the
program:
840D/828D SINUMERIK Operate
Section 3
Notes