Siemens Sinumerik 840D Operating Turning page 464

Section 2
Notes
B634
B634
Simple programming example
2.2 Programming example: Spigot
The program shown below is to be programmed:
1. Program the first lines of the program by inserting
the following G code commands:
N100 G54 G17 G90
N110 G0 X400 Z200
2. Insert now a blank for the simulation into the pro-
gram.
Press the HSK 1.6 "Various" to open the work area
"Various".
Press the VSK 1 "Blank".
The following parameter window for the blank input
opens.
3. Insert the values shown below into the parameter
mask:
Confirm your inputs by pressing the VSK 8 "Accept".
The following line is inserted into the program:
N120 WORKPIECE(,,"","CYLINDER",192,0,-110,-
100,100)
Page 4 840D/828D SINUMERIK Operate